So why does your hot water run out so quickly?

Scenario #1: Your family has grown

This is an obvious issue. However, it might not just be your family has a few new additions, but also that your family has matured. Whether there are more people using hot water, or more people are taking longer showers or baths, this is draining your water tank more quickly. As a result, it might just be you need a larger tank.

Scenario #2: Too much demand at once

Another common problem is putting too much demand on the hot water at once. This could mean anything from running a dishwasher or laundry load while someone is in the shower, to two people trying to take a shower in separate showers at the same time. Also, you might find the reverse issue. You’re in the shower and suddenly you get scalded.

This can happen when someone runs the cold water when you are in the shower, or if someone flushes the toilet. The easy solution is to simply avoid putting too much demand on your hot water all at once. Although this can be a challenge in a full house, it can be coordinated to work out. Otherwise, it’s shower taker beware! Be prepared to be chilled!

Scenario #3: Wrong temperature setting

It could be that your water heater is simply at the wrong setting. Ideally, you should have your temperature set to between 120 to 140 degrees. If it is below 120, simply turn up the heat. Just be careful not to set it too high as you can seriously scald someone. If you have small children, reduce the risk of burns by choosing a comfy 125.

Scenario #4: Broken dip tube

If temperature issues are more recent, it might be because a dip tube broke. To see if this is the case, you can look for small bits of plastic that might be found in your shower head, drain strainers, or appliance filter screens. If you do find plastic bits, your water heater’s dip tube is probably damaged. It is used to send cold water to the bottom of the tank to get heated up. When it breaks cold water stays at the top and so it comes out the hot water side instead. As well, because it isn’t below to get heated, it stays cold. If this is the case, call a professional to confirm the issue and replace the dip tube.

Scenario #5: Sediment build-up

Another issue that can interfere with hot water is sediment build up in the water tank. This happens over time as your water heater ages. If you haven’t maintained your water heater with annual system flushes, this could be the problem. Sediment is formed from loose minerals that are found naturally in water. When they settle at the bottom of the tank, it causes your tank to run out of hot water quickly.

Sediment can be things such as sand, silt, or rust that take up space in your water tank. As a result, your hot water supply dwindles. However, another issue with sediment is that your heating elements heat the sediment instead of the water, so it is slower to heat. The only way to remedy this issue is to flush out the system. While you can try doing this yourself, it might be best left to a professional from New Era Plumbing who knows how to drain the water heater without the risk of flooding your basement!

A good rule of thumb is to arrange for annual water heater maintenance. This helps you avoid issues such as sediment build up and also provides a check-up to spot issues like broken dip tubes.

Find Long-Term Solutions

This is where we come in. As your Dracut water heater specialists, we can provide water heater maintenance, repairs, and replacement so you never worry about cold showers again. Give us a call today!

Posted in

I am proud of the skills and knowledge I have gained during my 15 years working Plumbing and HVAC. I started as an apprentice, assigned to do basic tasks like carrying tools and materials, drilling holes and digging trenches. I was hungry to learn and expand my career opportunities, so I enrolled in an after-school training program for both my HVAC training and Journeyman license. I loved learning about both trades and felt like I was finally on the right track. When I passed my Journeyman Plumbing exam, I started to do side jobs which allowed me to experience the business owner side of things. This completely changed my perspective on my career and drove me to continue to pursue owning my own Plumbing & HVAC business. I continued my training and earned my Master’s license. With the support of my amazing wife, I started my own business SDP Plumbing, Heating and Cooling in 2016. Three years later, we rebranded the company as New Era Plumbing & HVAC. I could not be more proud of my career path and my company. Our core values are: Faith, Family, Empathy, Giving, Service and Quality. I train our team on adhering to these every day. We love taking care of our customers and are proud to serve our community.

Danny Pen


1 New Boston Rd Unit D,
Contact us at (978) 344-6833 to get started!

We are proud to be able to provide the highest quality services at the most competitive rates in the industry!